al
plate_separation_mode
psm
Trendsetter_NEWS
Normally on a TS News device, the plate separator arms are not used. However, for large
plates, they may be needed to avoid scratching the plate behind it. This parameter can
be set to enable the separator arms. Another option is to turn the air jets on while winding
the plate onto the drum.
Set this parameter to:
0 normal operation
1 use separator arms for plate size larger than 26 inches (mainscan direction)
2 use air jets during load
3 use separator arms for plate size larger than 26 inches (mainscan direction) and air jet
4 use separator arms for all plate sizes
6 use separator arms for all plate sizes and the air jets
byte
0
0 to 7
Only present in TS News firmware versions 1.12 and above.
cfg